Operation Manual

CyberLink PowerDirector 6
28
2. Click to open the DV camcorder capture function. (You may
have to wait a few moments as CyberLink PowerDirector switches
capture modes.)
3. Locate the position where you would like to begin capturing. You
may do this in one of the following ways:
• Use the playback buttons.
• Enter a timecode, then press the Enter key on your
keyboard seek to that timecode.
• Drag the time slider .
4. Set your capture options (if necessary). See "Capture Options" on
page 19.
• Check Non-realtime to continue processing captured video
after the original video stops playing in order to ensure that
no frames are dropped. Capturing video at a higher speed
reduces processing time, but yields video of a lower quality.
Capturing better quality video requires more CPU power
and more time to complete.