Operation Manual

Chapter 2: Pre-production
37
4. Click . The DV Manual Scan/Batch Capture dialog box
opens.
5. Click .
6. Navigate to the mark in time by doing one of the following:
• Use the playback buttons.
• Enter a timecode, then click to seek to that timecode.
• Drag the time slider .
7. Click to set the mark in point.
8. Navigate to the mark out time, then click to set the mark out
point. The intervals you set appear in the pane to the right of the
preview window.
Note: You can continue to set intervals of clips to capture. Each interval,
however, must have a duration of at least two frames.
9. Click Start to begin batch capture. CyberLink PowerDirector
rewinds your tape to the position of the first clip, then begins
capturing all of the intervals you have checked. The video plays in