Operation Manual

Chapter 2: Pre-production
39
2. Click to open the HDV camcorder capture function. (You
may have to wait a few moments as CyberLink PowerDirector
switches capture modes.)
3. Locate the position where you would like to begin capturing. You
may do this in one of the following ways:
• Use the playback buttons.
• Enter a timecode, then click to seek to that timecode.
• Drag the time slider .
4. Set your capture options (if necessary). See "Capture Options" on
page 19.
5. Click to begin capture. The video plays in the preview window
as you capture.
6. Click to stop capture before completion. The clip you have
captured will appear in the Captured Clips area.