Operation Manual

CyberLink PowerDirector 6
62
• Enable CyberLink MPEG@Best: Check to balance capture speed
and video quality when you capture MPEG video.
• Do not detect scenes during capture: Check this option if you
do not want to activate the auto scene detection function during
capture.
• After capture, detect scenes by changing of video frames:
Check this option to perform scene detection during video
capture. In scene detection, CyberLink PowerDirector compares
captured frames to decide when there is a scene change. Each
scene is saved as a file as recording continues.
• During capture, detect scenes by timecode, and save each
scene as a separate file (DV-VCR mode only): Check this option
to detect scene-break signals and to save each scene as a
separate file. (DV camcorder generate a scene-break signal on
the tape whenever users release the REC button.) This feature is
only available in DV camcorder capture.
• DV Parameters button: Click this button to set the buffer
parameters for your DV camcorder. Setting a buffer time ensures
that your DV camcorder and your batch capture or DV writing
device begin at the same time. Without a buffer, batch capturing
or writing to tape may begin before the camcorder is engaged.