Operation Manual

Chapter 3: Creating Your Story
47
• Select a photo and then click on the Set focus area button to
indicate what portion of a photo you want to be the focus in a
photo cell.
• Indicate the maximum number of photos that can be displayed
on a slide.
Adding Video, Photos and Audio to
the Workspace
The sections below describe the procedures for adding each kind of
media clip into the workspace.
Note: You may prefer to add clips in Storyboard view, since this view is
simpler than the Timeline view. However, clips can only be added to the
Video track in this view. Therefore, this section uses the Timeline view in all of
the procedures.
Add Video Clips & Photos
You can add video clips and photos to either the Master Video Track or
a PiP (picture-in-picture) Track.
Note: You can add additional PiP tracks to your project’s timeline in the Track
Manager, allowing you to have up to six PiP objects displayed on a video at
the same time. See "Track Manager" on page 40 for more information.
To add video clips or photos to the workspace, you can:
• Click to add the clip to the Video Track or
to add the clip to a PiP Track.
• Drag clips to a desired position in the Video or a PiP Track. When
adding clips to the Master Video Track, you cannot leave an
empty gap between adjacent clips. Clips added to the end of the
Master Video Track follow immediately after the final clip in that
track.