Instruction manual

105 Telnet Menu System

Cybernetics UM-MV-86-B1-0801

C h a p t e r 4

Telnet Menu System

This section describes the telnet menu system available used for configuration and oper-

ation of the miSAN-V-Series.

To use the telnet menu system, the unit must be powered on and fully initialized. To con-

nect, open a standard telnet or terminal emulation program on a host system connected

to the local network. Point to the miSAN-V-Series Management LAN Ethernet interface

(“ETH0”) IP address (default is

192.168.1.1; see “Network Configuration” on page 60)

and the standard telnet port

23. The telnet client should be set to VT100 emulation, no

local echo, and 80

×24 characters or more.

Telnet access must be made via the TCP/IP network connection. If the unit includes more

than one network interface, a telnet session may by opened on any of the interfaces.

Access via a serial port is not supported.

Only one telnet session at a time is supported. If a second telnet session is opened from

the same or another host, on any interface, only a blank screen will be displayed.

When the telnet session connects, it will immediately display the following screen:

Type the username menu and press ENTER. The username “menu” is required for access

to the menu system. This username cannot be changed. If a password has been set, the

miSAN-V-Series will prompt for the password. If a password has not been set (default is

no password), an initial screen will be displayed, similar to the following: