Instruction manual

Telnet Menu System 109
UM-MV-86-B1-0801 Cybernetics
Load board code
This menu item loads firmware into the miSAN-V-Series from a connected physical
tape drive or via a TCP/IP network connection, for code upgrades as directed by
Cybernetics Technical Support.
Reset options to defaults
This menu item resets all settings to default values. Do not do this unless directed by
Cybernetics Technical Support.
Test system memory
This menu item will run a series of tests on the miSAN-V-Series system memory.
Total run-time is typically several minutes. If this item is selected, a confirmation dia-
log will be displayed. Pressing ENTER
will start the testing, and the screen will display
the following:
This may take a while...
When testing is complete, the screen will display the test result, as though “Display
debug output” had been selected from the “Offline Maintenance” menu.
Shut Down
This menu item is used for safely shutting down or rebooting the miSAN-V-Series.
Shutting down the miSAN-V-Series engine before powering off the unit helps insure
the integrity of data in the virtual tape cache.
If the “Shutdown” option is selected, a confirmation dialog will be displayed with the
following:
Shut down the unit for the power-off?
Press Enter to continue or ‘x’ to cancel.
Pressing ENTER will cause the miSAN-V-Series to disconnect the telnet session and
then shut down. When the miSAN-V-Series has finished shutting down, the unit will
remain running until powered off using the power button on the rear panel
If the “Reboot” option is selected, the shutdown routine explained above will occur,
and the miSAN-V-Series will restart and be ready for use again after about 90 sec-
onds.
Caution
Never power off the unit without first shutting down the HSTC engine.