Instruction manual

25 Setting Up the miSAN
Cybernetics UM-MV-86-B1-0801
2. Administrator
• Can do anything except
change encryption settings.
• Configures menu settings, networking, iSCSI, virtual devices, etc.
• Creates, deletes, and modifies VTs.
• Configures the user account.
• Can access SSH and telnet.
3.
User
• Limited set of abilities defined by the administrator.
Only the administrator account is enabled by default. You may optionally enable the other
two accounts. If you do not enable the security officer account, then all the privileges of
the security officer are granted to the administrator instead.
The Administrator
The administrator account may be protected by a password (there is no password by
default). You may set or change the administrator password in the menu "HSTC Options
-> Accounts -> Administrator Account". The administrator password is used for the follow-
ing purposes:
• Java applet login as administrator.
• SSH and telnet login as "menu".
• Viewing the debug messages web page.
• Viewing the menu settings web page.
• Viewing the hardware information web page.
• Performing a firmware upgrade.
The User
The user account is disabled by default. To enable the user account, go to the menu
"HSTC Options -> Accounts -> User Account". This menu allows the administrator to
enable or disable the user account, set the user password, and grant certain optional priv-
ileges to the user. Note that only the administrator can set the user password; the user
cannot set his own password.
When logged in as the user, many functions and menu options will be missing or high-
lighted in gray.
If the Web Browser prompts the Administrator for a username and
password to view a web pa
g
e on the unit, leave the username blank and
enter the administrator password.