Instruction manual

32 Setting Up the miSAN
Cybernetics UM-MV-86-B1-0801
When Shutdown is selected, a window will appear confirming the HSTC engine shut-
down (See Figure 2-3). Once confirmed, the HSTC engine will complete current opera-
tions. When the HSTC has finished shutting down, another window will appear saying the
miSAN-V-Series is then ready to be powered off. In most cases, shutting down the
miSAN-V-Series, also powers off the machine. If the device is still running after 30 sec-
onds, then press and hold the power button on the front panel until it powers off. Failure
to log off the iSCSI initiator before shutting down the miSAN-V-Series will result in error
messages
When
Reboot is selected, the shutdown routine explained above will occur, and the
miSAN-V-Series will restart and be ready for use again after about 90 seconds.
Note
If the Host machine is connected to the miSAN-V-Series via Microsoft
iSCSI Initiator software, it is necessary to log off the iSCSI connections
before shutting down in order to avoid possible data loss. Failure to log
off the iSCSI connections will cause Microsoft Windows to send
“Unsafe Device Removal” messages. Instructions for this procedure are
found in Appendix A “Microsoft iSCSI Initiator Client.
Figure 2-3 “Confirm shutdown method” Window