Instruction manual

69 Operating the Web Control Panel
Cybernetics UM-MV-86-B1-0801
The configured emulations can be selected for use by virtual devices using the
“Virtual Device Emulations” menu (See “Virtual Device Emulations” on page 52).
Debugging
This menu selection presents a set of menu items used for enabling specific types
of debugging messages. Do not change these settings unless directed by Cyber-
netics Technical Support.
Host iSCSI Debug Messages
This menu selection presents a set of menu items used for enabling specific types
of debugging messages. Do not change these settings unless directed by Cyber-
netics Technical Support.
Information
This menu displays information about the installed miSAN-V-Series code and devices.
Nothing can be changed through this menu.
Product Information
This menu item displays the installed CY-HSTC engine code version (“Version”), unit
serial number (“EUI serial #”), HASP security device ID number (“ID #), host bus mask
(“Host bus mask”), miSAN-V-Series flags (“Flags”), Ethernet interface(s) (numbered
as “eth”), and MAC address(es) (“HWaddr”). “Host bus mask” is a number indicating
which SCSI ports are assigned as targets for host systems.
“Host bus mask” is a number indicating which SCSI ports are assigned as targets for
host systems.
Note
Enabling support for each emulation requires a passcode. Contact
Cybernetics Technical Support to identify numbered emulations and
obtain passcodes for specific manufacturer models.
Note
The “Speed test mode” setting is used to test the data transfer rate
between the host computer and the miSAN-V-Series independently of
the connected SCSI tape devices. When Enabled, the miSAN-V-Series
will discard all data from host write commands. For host read
commands, the miSAN will return random data.