Instruction manual

87 Operating the Web Control Panel
Cybernetics UM-MV-86-B1-0801
The “Copy selections” tab is used to offload the set of virtual tapes specified using
the “Setup offload...”option to the physical tapes.
The “Copy profiles” frame (See Figure 3-40) allows for selecting and using one of
the saved copy profiles to automatically assign virtual tapes to physical tapes
(See “Physical Stacker Copy Profiles” on page 43).
The “Copy options” tab is used for specifying when to initiate the copies. It pre-
sents two sets of buttons for setting the frequency of the copies and an option for
delaying their start (See Figure 3-41).
You can choose how many times the jobs will offload before stopping:
Offload each virtual tape only once – If you need to do the offload again, you
can start more jobs later.
Run jobs continuously, offloading after each backup to VT – To stop offload-
ing, suspend the job or remove the physical tape.
Figure 3-39 “Copy selections” Tab
Figure 3-40 “Copy profiles” Frame
Figure 3-41 “Copy options” Tab