Integration Guide

Important FCC no�ce:
In accordance with FCC Part 15C and RSP-100, this module is listed as a Modular Transmitter
device.
The user must comply with all of the instructions provided by the Grantee, which indicate the
installation and/or operating conditions necessary for compliance.
The antenna of this transmitter must not be co-located or operating in conjunction with any other
antenna or transmitters within a host device, except in accordance with FCC multitrans
mitter
product approval procedures. Only external antenna (Max. gain of dipole antenna is 2.74dBi) as
AN2400-39A14BBF can be used for this module, and the printed antenna is not used.
The module has allowed to use. In USA and Canada, the number of operation frequency channel
is 11.
Technical Specifica�on
Value
Opera�ng Frequencies
802.11b/g/n
HT20
: 2412 MHz
~
2462 MHz
Channel
Spacing
802.11b/g/n
HT20
:
5MHz
C
hannel number
802.11b/g/n
HT20
:
11
Opera�on Voltage
12V
dc
Modula�on
CCK, DQPSK, DBPSK for DSSS
64QAM, 16QAM, QPSK, BPSK for OFDM
Antenna gain
2.
16
dBi
The final Host is required to comply with all applicable FCC equipment authorization regulations,
requirements and other device functions that are not associated with the transmitter module. For
example, compliance must be ensured:
- regulations for other transmitter portions within a host product;
- requirements for unintentional radiators (Part 15 Subpart B), such as digital devices,
computer peripherals, radio receivers, et
c.;
- additional authorization requirements for the non-transmitter functions on the transmitter
module (i.e., SDoC or certification) as appropriate (e.g., Digital radio transmitter modules
usually contain digital logic functions for the Data interface to the Host product)
- need to follow the instructions shown in the FCC publication “KDB 996369 D04 Module
Integration Guide” which can be found under the following link: xxxxxxxxxxx
Changes
or modifications not expressly approved by the host device or module manufacturer
could void the user’s authority to operate the equipment.
FCC Label Instructions
The outside of final products that contains this module device must display a label
referring to the enclosed module. This exterior label can use wording such as the
following: “Contains Transmitter Module FCC ID: 2AFG8CPWMU01” or “Contains FCC ID:
2AFG8CPWMU01.” Any similar wording that expresses the same meaning may be used.
Additionally, there must be the following sentence on the device, unless it is too small to carry it: