User`s manual

4
Copyright © 2008 CyberPower Systems, Inc.
Refer to the battery connection diagram:
1. Connect the battery pack’s output cord into the UPS’s input port.
2. All battery pack module must connect in right type, red to red, black to black, green to
green.
3. When connecting with numerous battery packs to extend the battery runtime, link the
output plugs of all except the one that connects to the UPS.
CAUTION! If AC input charger of battery pack from UPS outlet/output, it will occupy UPS
output rating.
Battery Charger Consumption: 100VA (approximate) per battery pack
CAUTION! Before connecting to the UPS, make sure to turn off the circuit breaker.
CAUTION! Do not disconnect the battery pack when UPS is operating.
CAUTION! Do not connect the battery pack into itself.
CAUTION! Additional battery packs are to be connected in parallel connected, the voltage
maintains the same, yet the battery amp-hour capacity depends on the numbers of battery
packs in the set up.
CAUTION! Do not connect more than the upper limit of the battery packs to the UPS. (The
battery packs limits are stated in the user’s manual.)
Battery Connection to UPS
How to set the number of battery packs connected to the UPS?
The UPS must be equipped with the appropriate number of external battery packs. In order to
recognize the battery packs, there are two ways to set up the UPS:
 PowerPanel
®
Business Edition.
 Press the display toggle to set up the correct battery pack numbers.
*For battery run time table information, visit www.CPSww.com or contact.
Trouble Shooting
Problem Possible Cause Solution
The UPS LCD does not
perform expected
runtime.
Do not set the UPS to
recognize the battery
pack(s).
By pressing the display toggle to select
functions. Then, set up the correct battery
pack numbers. The default setting is 0.
The battery pack does
not work.
Batteries are not fully
charged.
Allow the battery pack to charge for 24
hours. Do not expect full runtime during
this initial charge period.
Specified battery pack models can use AC
to shorten charge time.
The status of circuit
breaker is off.
Switch on the circuit breaker.
The fuse blew.
Contact CyberPower Systems.
Open the cover on the rear panel and
replace the new fuse.