User`s manual

5. Slide the battery compartment cover completely off of the unit.
6. Remove the batteries from the compartment.
7. Disconnect the battery wires from the batteries.
8. Install the replacement batteries by connecting the red wire (+) and black wire (-) to the same color
connectors from the battery pack.
9. Put the batteries back into the compartment.
10. Slide back the battery compartment cover and tighten the retaining screw.

11. Recharge the UPS for 8-16 hours to fully charge the battery.
REMINDER: Batteries are considered HAZARDOUS WASTE and must be disposed of properly.
Almost any retailer that sells lead-acid batteries collects used batteries for recycling.

  
DEFINITIONS FOR ILLUMINATED LCD INDICATORS
6
1. ONLINE: The UPS is supplying utility power to
connected equipment.
2. BATTERY: During a severe brownout or
blackout, this icon appears and an alarm sounds
(two short beeps followed by a pause) to indicate
the UPS is operating from its internal batteries.
During a prolonged brownout or blackout, the
alarm will beep rapidly every 1/2 second (and the
BATT.CAPACITY meter shows one 20% capacity
segment shaded. The capacity depends on how
much load added and the runtime left.) to indicate
the UPS’s batteries are nearly out of power. You
should save files and turn off your equipment immediately or allow the software to shut the system
down.

3. Energy-Saving: The UPS in energy-saving bypass mode. See “CyberPower GreenPower UPS
TM
Technology” section for more information.
4. LOAD capacity / Sensitivity setup: This meter displays the approximate output load level (in
20% increments) of the UPS battery outlets. It can also be sensitivity setup meter if you are in
programming mode. It is to control the sensitivity of the UPS to switch to Battery Mode by
selecting UPS shutdown voltage range. The higher the sensitivity, the easier the UPS will switch to
Battery Mode.