User manual

CPS3000PIE
12
Battery Icon Flash Beep Once Battery Missing- In Line
Mode Battery
Missing.
Turn the EPS off, check
battery wiring and
presence of battery
Fault Icon 1. Rapid Beep
2. Recurring Beep
3. Long Beep
1. Low Battery
Output-Off
-- Insufficient battery
capacity.
2. Over Charge or AVR
Error-- In Line Mode,
battery is overcharged
or AVR is faulty.
3. Short Output-Off --
Output Short Circuit
Protection
1. Recharge the
battery.
2. Inform service
agents.
3. Check the EPS
output to see if
there is a short
circuit.
Can Not Start Up None 1. Line Input/Output
Error Output-Off --
incorrect Input/Output
connection
2. Cold Start Battery
High Voltage
Output-Off -- the
battery voltage is too
high during cold start.
1. Check Input/Output
connection.
2. Check the reason
for battery
over-voltage.
TROUBLESHOOTING
Problem Possible Cause Solution
Full-time surge protection
outlets stop providing
power to equipment.
Circuit breaker button is
projecting from the side
of the unit
Circuit breaker has tripped
due to an overload.
Turn the EPS off and unplug at least
one piece of equipment. Wait 10
seconds, reset the circuit breaker by
depressing the button, and then turn
the EPS on.
The on/off switch is
designed to prevent damage
by rapidly turning it off and
on.
Turn the EPS off. Wait 10 seconds
and then turn the EPS on.
The EPS will not turn on.
Mechanical problem. Contact Cyberpower Systems via
phone at [phone] or visit
our website at
www.cyberpowersystems.com