User manual

CPS3000PIE
2
K01-0000010-00
SAFETY AND EMC INSTRUCTIONS
(SAVE THESE INSTRUCTIONS)
This manual contains important safety instructions. Please read and follow all instructions
carefully during installation and operation of the unit. Read this manual thoroughly before
attempting to unpack, install, or operate your Emergency Power System (EPS).
CAUTION! To prevent the risk of fire or electric shock, install in a temperature and
humidity controlled indoor area free of conductive contaminants. (Please see specifications
for acceptable temperature and humidity range).
CAUTION! To reduce the risk of electric shock, do not remove the cover.
CAUTION! EPS must be connected to an AC power outlet with circuit breaker
protection. Do not plug into an outlet that is not grounded. If you need to de-energize this
equipment, turn off and unplug the unit.
CAUTION! To avoid electrical shock, turn off the unit and unplug it from the AC power
source before servicing EPS, replacing the external battery or installing equipment.
CAUTION! To reduce the risk of fire, only connect the EPS to a circuit with 25 amperes
maximum branch circuit over-current protection in accordance with the CE requirement.
CAUTION! The building wiring socket outlet (shockproof socket outlet) must be easily
accessible and close to the EPS.
CAUTION! Please use only VDE-tested, CE-marked mains cable (e.g. the mains cable
of your equipment) to connect the EPS to the building wiring socket outlet (shockproof
socket outlet).
CAUTION! Please use only VDE-tested, CE-marked power cables to connect the loads
to the EPS.
CAUTION! When installing the equipment, ensure that the sum of the leakage current of
the EPS and the connected equipment does not exceed 3.5mA.
CAUTION! This is permanently connected equipment and only qualified maintenance
personnel may carry out installations.
CAUTION! Do not disconnect the mains cable on the EPS or the building wiring socket
outlet (shockproof socket outlet) during operations since this would remove the protective
ground of the EPS and of all connected loads.