User Manual for: CPS320SL / CPS375SL / CPS500SL / CPS575SL / CPS650SL and PowerPanel™ Software ADDITIONAL INSTALLATION TIPS CAN BE FOUND AT: http://www.cyberpowersystems.com/faq_sl.
TABLE OF CONTENTS Description……………………. ………1 Determining Power Requirements…..1 Hardware Installation Guide………….2 Software Installation Guide…………..3 Software User Manual………………..4 LED Indicators……………………………..7 Troubleshooting Guide……………………8 Specifications………………………………8 Battery Replacement Instructions…….….9 Warranty…………………………………...10 Thank you for purchasing a CyberPower Systems Product.
CPS320SL / CPS375SL / CPS500SL / CPS575SL / CPS650SL Guaranteed Uninterruptible Power System DESCRIPTION X Battery/Surge Outlets Provides three battery powered/surge outlets for connected equipment and insures temporary uninterrupted operation of your equipment during a power failure. Y Full-Time Surge Protection Outlets Provides three always on surge suppression outlets. Z Power Switch Can be used as a mater on/off switch for equipment connected to the battery power supplied outlets.
HARDWARE INSTALLATION GUIDE 1. Your new UPS may be used immediately upon receipt. However, recharging the battery for at least four hours is recommended to insure that the battery’s maximum charge capacity is achieved. Charge loss may occur during shipping and storage. To recharge the battery, simply leave the unit plugged into an AC outlet. The unit will charge in both the on as well as the off position. 2.
CPS320SL / CPS375SL / CPS500SL / CPS575SL / CPS650SL Guaranteed Uninterruptible Power System POWERPANEL™ SOFTWARE INSTALLATION GUIDE (Note: Use of the software is optional. The UPS will provide surge suppression and battery backup without the software. You must use the software if you wish to have the automatic shutdown feature). FOR WINDOWS 95/98/Me 1. 2. 3. 4. 5. 6. 7. 8. 9. Turn the UPS off and unplug it.
13. Click Install. 14. Follow the on-screen instructions. 15. Once the software is installed, remove the floppy disk and restart your computer. When your computer restarts, the PowerPanel™ software will appear on your screen for a few seconds, and then minimize. It will appear as a blue and white battery icon located in the system tray, near the clock. POWERPANEL™ SOFTWARE USER MANUAL OVERVIEW PowerPanel™ version 2.
CPS320SL / CPS375SL / CPS500SL / CPS575SL / CPS650SL Guaranteed Uninterruptible Power System 3. 4. 5. 6. 7. Time Between Power Failure and Shutdown Process: This user adjustable setting determines how long the UPS will run on battery before starting to shut down the system. If this is not checked, the unit will run on battery until the low battery condition is met (2 minutes of backup time remaining), and then start the shutdown process.
Uninterruptible Power Supply is installed on. Click OK. Acknowledge the message that the UPS is in an unknown state and exit to the desktop. USING THE WINDOWS 2000 UPS SERVICE If you are running Windows 2000, you may choose to run the Windows 2000 UPS service instead of PowerPanel™. You can run either PowerPanel™ or the Windows 2000 UPS service, but not both. To Configure the Windows 2000 UPS Service: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. Click on Start, point to Settings, then Control Panel.
CPS320SL / CPS375SL / CPS500SL / CPS575SL / CPS650SL Guaranteed Uninterruptible Power System DEFINITIONS FOR ILLUMINATED LED INDICATORS CONDITION On Off Off On/Off Set Set Off Two Beeps Off On/Off Set Rapid Beeps Off Off Up Two Beeps or Rapid Beeps Off On/Off Set Long Beep On/Off On Set None 7 Utility Failure- the UPS is providing power to battery power-supplied outlets from its battery. Utility Failure- The UPS is providing battery power.
TROUBLESHOOTING Problem Possible Cause Solution Full-time surge protection outlets stop providing power to equipment. Circuit breaker has tripped due to an overload. Turn the UPS off and unplug at least one piece of equipment. Wait 10 seconds, reset the circuit breaker by depressing the button, and then turn the UPS on. The UPS does not perform expected runtime. Battery not fully charged. Recharge the battery by leaving the UPS plugged in.
CPS320SL / CPS375SL / CPS500SL / CPS575SL / CPS650SL Guaranteed Uninterruptible Power System EXPECTED RUNTIME IN MINUTES Desktop PC with 15” Monitor Desktop PC with 17” Monitor Desktop PC with 21” Monitor CPS320SL 6–9 4–6 Not Advised CPS375SL 8 – 12 6-9 Not Advised CPS500SL 10 – 14 8 – 12 6 - 10 CPS575SL 17 – 21 15 – 19 13 – 17 CPS650SL 18 – 24 16 – 22 14 – 19 REPLACING THE BATTERY CAUTION! Read and follow the IMPORTANT SAFETY INSTRUCTIONS before servicing the battery.
Limited Warranty And Power Control Guarantee In purchasing a 320SL, 375SL, 500SL, 575SL or 650SL in the United States or Canada, the original end user receives a Limited Warranty and CyberPower’s Power Control Guarantee from Cyber Power Systems (USA), Inc. (for ease of reading, referred to as “CyberPower”). The Limited Warranty and the Power Control Guarantee are intended to be the initial end-user’s exclusive rights and remedies.
CPS320SL / CPS375SL / CPS500SL / CPS575SL / CPS650SL Guaranteed Uninterruptible Power System POWER CONTROL GUARANTEE If you are the Initial Purchaser and the Product is still covered by the Limited Warranty, the Power Control Guarantee provides protection for damage to equipment connected to the Product (“Connected Equipment”), subject to certain terms and limitations. The Power Control Guarantee is not “first dollar” coverage.
3. The amount(s) of all payment you have or are entitled to receive from insurance, other warranties, extended warranties, or from other sources or persons for the Connected Equipment or damage to such equipment so that CyberPower’s maximum liability shall be reduced to reflect all such other payments or sources of recovery: CyberPower 320SL-$30,000.00 CyberPower 375SL-$35,000.00; CyberPower 500SL-$40,000.00; CyberPower 575SL-$45,000.00; CyberPower 650SL-$100,000.00.
CPS320SL / CPS375SL / CPS500SL / CPS575SL / CPS650SL Guaranteed Uninterruptible Power System DO NOT USE FOR MEDICAL OR LIFE SUPPPORT EQUIPMENT OR OTHER HIGH RISK ACTIVITIES. CyberPower does not sell the Products for use in high-risk activities.
FCC Notice This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
