User`s manual

5. Press the power switch to turn the unit on. The Power On indicator light will illuminate and the unit will “beep”.

If an overload is detected, an audible alarm will sound and the unit will emit one long beep. To correct this,

turn the UPS off and unplug at least one piece of equipment from the battery power supplied outlets. Make

sure the circuit breaker is depressed and then turn the UPS on.

6. To maintain optimal battery charge, leave the UPS plugged into an AC outlet at all times.

7. To store the UPS for an extended period, cover it and store with the battery fully charged. While in storage,

recharge the battery every three months to ensure battery life.

8. To use PowerPanel® Business Edition software, connect the serial cable to the serial port or the USB port on

both the UPS and the computer. These OR units include one serial port, one dry contact, and one USB port

to allow connection and communication between the UPS and computers. Serial port II produces basic

information for equipment that can utilize a dry contact UPS. The primary computer (with PowerPanel®

Business Edition installed) is the computer that you will use to control the UPS and make changes to the

operation of the UPS. When there is a power failure, the computer connected to the Primary port will start to

shut down after a user controlled delay. PowerPanel® Business Edition will save and close any open files

prior to shutting down the system.

DESCRIPTION

BASIC OPERATIO