CPS525SL / CPS725SL Guaranteed Uninterruptible Power System User Manual for: CPS525SL / CPS725SL with USB Interface and PowerPanel™ Software ADDITIONAL INSTALLATION TIPS CAN BE FOUND AT: 1
CPS525SL / CPS725SL Guaranteed Uninterruptible Power System www.cyberpowersystems.com/FAQs.htm TABLE OF CONTENTS Battery Replacement Instructions.....7 LED Indicators………………………..8 Trouble Shooting Guide…………… .9 Specifications……………………….10 Warranty... ... ... ... ... ... ... ... ... ... .11 Safety Instructions....... ... .. ... ... ... ...1 Description……………………………..1 Determining Power Requirements…..2 Hardware Installation Guide………….2 Software Installation Guide…………..
CPS525SL / CPS725SL Guaranteed Uninterruptible Power System IMPORTANT SAFETY INSTRUCTIONS (SAVE THESE INSTRUCTIONS) This manual contains important safety instructions. Please read and follow all instructions carefully during installation and operation of unit. Read this manual thoroughly before attempting to unpack, install, or operate. CAUTION! To prevent the risk of fire or electric shock, install in a temperature and humidity controlled indoor area, free of conductive contaminants.
CPS525SL / CPS725SL Guaranteed Uninterruptible Power System INSPECTION The box should contain the following: (1) PowerPanel™ software (floppy disk); (1) serial interface cable (DB-9); (1) telephone communication cable; (1) user manual; (1) warranty registration card; (1) USB adapter ; (1) UPS unit. HOW TO DETERMINE THE POWER REQUIREMENTS OF YOUR EQUIPMENT 1. Make sure that the total Volt-Amp (VA) requirements of your computer, monitor and peripheral equipment does not exceed 1440 VA. 2.
CPS525SL / CPS725SL Guaranteed Uninterruptible Power System 5. 6. 7. 8. 9. 10. computer. The out jack with the telephone icon can be used to protect a telephone or fax machine. Plug the UPS into a 2 pole, 3 wire grounding receptacle (wall outlet). Make sure the wall branch outlet is protected by a fuse or circuit breaker and does not service equipment with large electrical demands (e.g. refrigerator, copier, etc…). Avoid using extension cords. If used, the extension cord must be rated for 15 amps.
CPS525SL / CPS725SL Guaranteed Uninterruptible Power System When your computer restarts, the PowerPanel™ software will appear on your screen for a few seconds, and then minimize. It will appear as a blue and white battery icon located in the system tray, near the clock. FOR WINDOWS NT 1. Click on Start, point to Settings, and then click Control Panel. 2. Double-click the UPS Icon. 3. Remove the check mark from the box labeled UPS is installed on. 4. Click OK. 5.
CPS525SL / CPS725SL Guaranteed Uninterruptible Power System PowerPanel™ version 2.03 or greater is designed for use with Windows 95, Windows 98, Windows Me, Windows NT and Windows 2000. The latest version can be downloaded from www.cyberpowersystems.com/downloads.htm. It works in conjunction with the UPS to provide full protection of valuable computer systems, applications and data.
CPS525SL / CPS725SL Guaranteed Uninterruptible Power System 7. About Button: This button will display information about the software as well as contact information. POWERPANEL™ LOG WINDOW 1. Display Window: This area displays either the Event Log or the Closed Application Information. 2. Event Log: Select this option to view PowerPanel™ events such as program start, program end, power failure and low battery. 3.
CPS525SL / CPS725SL Guaranteed Uninterruptible Power System To Configure the Windows 2000 UPS Service: 1. Click on Start, point to Settings, then Control Panel. 2. Double-click on Power Options. 3. On the UPS Tab, click Select. 4. In the UPS Selection Dialog Box, under Select Manufacturer, select Generic. 5. Under Select Model, select Custom. 6. On the UPS Tab, click Configure. 7. Set Power Fail/On Battery to Negative. 8. Set Low Battery to Negative. 9. Set UPS Shutdown to Positive. 10. Click OK.
CPS525SL / CPS725SL Guaranteed Uninterruptible Power System CAUTION! A battery can present a high risk of short circuit current and electrical shock. Take the following precautions before replacing the battery: 1. Remove all watches, rings or other metal objects. 2. Only use tools with insulated handles. 3. Do not lay tools or metal parts on top of battery or any terminals. 4. Wear rubber gloves and boots. 5. Determine if the battery is inadvertently grounded.
CPS525SL / CPS725SL Guaranteed Uninterruptible Power System breaker and turn the unit on. On/Off On Set Electrical Wiring Fault- This indicates a wiring problem with the AC outlet such as bad ground, miss ground, or reversed wiring. User is advised to disconnect all electrical equipment from the outlet and have an electrician check the outlet to insure proper wiring.
CPS525SL / CPS725SL Guaranteed Uninterruptible Power System TROUBLE SHOOTING Problem Possible Cause Solution Full-time surge protection outlets stop providing power to equipment. The UPS does not perform expected runtime. Circuit breaker has tripped due to an overload. Turn the UPS off and unplug at least one piece of equipment. Wait 10 seconds, reset the circuit breaker by depressing the button, and then turn the UPS on. Battery not fully charged. Battery is slightly worn out.
CPS525SL / CPS725SL Guaranteed Uninterruptible Power System Additional troubleshooting information can be found at www.cyberpowersystems.com/FAQs.
CPS525SL / CPS725SL Guaranteed Uninterruptible Power System SPECIFICATIONS Capacity CPS525SL CPS725SL 525VA(300W) 725VA(400W) Input Voltage on Utility 100V to 140V Input Frequency 57 Hz to 63 Hz On-Battery Output Voltage 120Vac ± 5% Transfer Time 4ms Typical Max. Load for UPS Outlets (3 Outlets) 525VA(300W) 725VA(400W) Max. Load for Full-Time Surge Protection outlets (6 Outlets) 12 Amps On-Battery Output Wave Form Simulated Sine Wave Form Operating Temperature + 32°F to 95° F.
CPS525SL / CPS725SL Guaranteed Uninterruptible Power System Limited Warranty And Power Control Guarantee In purchasing a 525SL or 725SL in the United States or Canada, the original end user receives a Limited Warranty and CyberPower’s Power Control Guarantee from Cyber Power Systems (USA), Inc. (for ease of reading, referred to as “CyberPower”). The Limited Warranty and the Power Control Guarantee are intended to be the initial end-user’s exclusive rights and remedies.
CPS525SL / CPS725SL Guaranteed Uninterruptible Power System or not the Initial Customer makes a claim for recovery, including but not limited to a 14
CPS525SL / CPS725SL Guaranteed Uninterruptible Power System claim under any applicable insurance, other warranty, or extended warranty. The Power Control Guarantee is separate from the Limited Warranty, but they are related. The Limited Warranty does not cover Connected Equipment, but as is explained below, to be covered under the Power Control Guarantee, the Connected Equipment must have been damaged due to a failure of the Product that is covered by the Limited Warranty.
CPS525SL / CPS725SL Guaranteed Uninterruptible Power System The Limited Warranty and the Power Control Guarantee are the only and the exclusive express warranty of CyberPower with respect to the Product. This exclusion of other express warranties applies to written and oral express warranties. Any Implied Warranty of Merchantability or for Fitness for a Particular Purpose, if applicable to the Product, is limited in duration to the period of ownership by the Initial Customer.
CPS525SL / CPS725SL Guaranteed Uninterruptible Power System For more information, contact us at: CyberPower Systems (USA), Inc. 5555 12th Avenue East, Suite 110 Shakopee, MN 55379 Tel: (952) 403-9500 Fax: (952) 403-0009 Toll-Free: (877)-297-6937 Email: sales@cyberpowersystems.com Web: www.cyberpowersystems.com Entire contents copyright ©2002 CyberPower Systems, Inc. All rights reserved. Reproduction in whole or in part without permission is prohibited.
