PRODUCT REGISTRATION Thank you for purchasing a CyberPower product. This UPS is designed to provide unsurpassed power protection, operation, and performance during the lifetime of the product. Please take a few minutes to register your product at: www.CyberPowerSystems.com/registration. Registration certifies your product’s warranty, confirms your ownership in the event of a product loss or theft, and entitles you to free technical support.
INSTALLING YOUR UPS SYSTEM UNPACKING Inspect the UPS upon receipt. The box should contain the following: (a) UPS unit (b) User’s manual (c) Coaxial Cable (d) USB A+B Type cable (e) Function Setup Guide PowerPanel® software is available on our website. Please visit www.cyberpowersystems. com and go to the Software Section for a free download. SUPPORTS ACTIVE PFC POWER SUPPLIES This CyberPower UPS system supports High Efficiency power supplies with Active Power Factor Correction (Active PFC).
BASIC OPERATION 1. Power Switch Used as the master on/off switch for equipment connected to the battery power supplied outlets. 2. Power On Indicator This LED is illuminated when the utility power is normal and the UPS outlets are providing power, free of surges and spikes. 3. LCD Module Display High resolution and intelligent LCD display shows all the UPS information using icons and messages. For more information please review the “Definitions for Illuminated LCD Indicators” section below. 4.
DEFINITIONS FOR ILLUMINATED LCD INDICATORS -continued 11. INPUT Meter 12. EVENT This meter measures the AC voltage that the UPS system is receiving from the utility wall outlet. The UPS is designed, through the use of automatic voltage regulation, to continuously correct output voltage to connected equipment to a safe 110/120 voltage output range.
TROUBLESHOOTING -continued Problem PowerPanel® is inactive (all icons are gray). The USB power ports are not providing power to the connected devices. Possible Cause Solution The unit is not providing battery power. Shutdown your computer and turn the UPS off. Wait 10 seconds and turn the UPS back on. This should reset the unit. The serial cable is not the cable that came with the unit. Please use the serial cable that came with the unit for the software.
