User Guide

OPERATION:
1. Power TV ON. 2. Power ON DVD player, game console, speakers, etc.
3. Energy saving timer’s default setting is 1 hour. The IR sensor’s blue LED light will blink for 15
minutes after one hour of last click of remote. Click any button on a TV remote or the volume
button on a cable provider’s remote to restart energy saving timer at zero. Blue LED light will
stop blinking for another hour.
4. Power OFF when done watching.
One Hour:
1. Hold the IR sensor button down
for 7 seconds.
2. LED light will flash 3 times, release.
3. Press IR sensor 1 time.
4. LED light will flash 1 time,
and timer will be 1 hour.
NOTE: IR sensor blinks for 1 minute after TV powers o. Power strip will turn o
energy saving outlets.
Two Hours:
1. Hold the IR sensor button down
for 7 seconds.
2. LED light will flash 3 times, release.
3. Press IR sensor 2 times, pausing
in between.
4. LED light will flash 2 times,
and timer will be 2 hours.
Need Additional Help? Feel free to contact our
Tech Support department with installation,
troubleshooting, or general product questions.
CyberPower Technical Support
1-877-297-6937 | tech@cpsww.com
cyberpowersystems.com
4241 12th Avenue E, Suite 400,
Shakopee, MN 55379, USA
MondayFriday, 7am–6pm (CST)
This document is believed to be accurate, but CyberPower reserves
the right to change or correct the contents and does not assume
any responsibility for omissions or errors. Entire contents copyright
© 2018 Cyber Power Systems (USA), Inc. All rights reserved. Repro-
duction in whole or in part without permission is prohibited.
CHANGING ENERGY SAVING TIMER
Audio Equipment
DVR
Cable Box
Gaming Console
DVD Player