User Manual

9
Copyright © 2018 Cyber Power Systems, Inc.
Functions
Options
Description
Low Transfer Point
98V
It is the setting of minimum output voltage.
If the utility voltage is usually low and the
connected equipment can work with this
condition, you can set Low Transfer Point
lower to avoid UPS going to battery mode
too often.
100V
102V
ESC
Sensitivity
Low
If the connected equipment can tolerate
more power events, select Low Sensitivity.
The UPS will go to battery mode less
often. If the connected equipment cannot
tolerate power events, select High
Sensitivity. The UPS will go to battery
mode more often.
Meduim
High
ESC
Self Test
Yes
During a Self Test, UPS will switch from
line mode to battery mode to simulate the
power failure condictions.
ESC
Buzzer
On
If OFF is selected, the unit will mute all
alarms except for overload condition.
Off
ESC
LCD Sleeping Mode
On
Select ON, the LCD will enter sleeping
mode if the display toggle is not touched
for 1 minute. To illuminate the LCD, simply
press the display toggle once. When OFF
is chosen, the LCD will never enter
sleeping mode.
Note: In Battery Mode, the LCD is always
on.
Off
ESC
Back to Default
Yes
Restore the UPS factory default settings.
ESC
ESC
-
Return to General Mode.
LCD SETUP FUCTIONS (continued)