User manual

Power Cord Retention Clip Installation- For IEC type ATS PDU

Input Power Cord Retention Cable Clip Installation

Step 1. Remove the screw next to the inlet.

Step 2. Attach the Cable Tie on the ATS PDU and secure it with the screw removed

in the previous step.

Step 3. Place a Power Cord Retention Cable Clip on the power cord. Align and

insert the Cable Tie into the Cable Clip as shown in the figure below.

Step 4. Push the Power Cord Retention Cable Clip until it touches the plug and

fasten the Retention Cable Clip like the figure below.

Installation Guide