User manual

14
©2014. CyberPower Systems, Inc. All rights reserved.
LED Indicators
Indicator Status Description
Source
Solid Green Selected source and power condition is normal.
Flashing Green Bankup source and power condition is normal.
Orange Power condition is abnormal.
Load
Green The aggregate current of each bank is normal.
Orange Near overload.
Red Overload.
Tx/Rx
Off The ATS PDU power is off.
On (Green) The ATS PDU power is on.
Flashing
Receiving/transmitting data packet.
Reset finished.
LINK
On Indicates the ATS PDU is connected to the LAN.
Off Indicates the ATS PDU is not connected to the LAN.
Outlet
On The outlet is on and providing power.
Off The outlet is off.
Local Management
LCD Operation
The LCD display provides instant information, such as source condition, voltage and current,
for the ATS PDU. In addition, users can use the interface to configure each PDU parameters
and control each outlet on the switched ATS PDU.
A. Scroll Mode: The ATS PDU information will display in following order
automatically when “Scroll Mode On” is configured.
Source A information
Source B information
Device Load
Bank 1 Current (2U series)
Bank 2 Current (2U series)
Bank 3 Current (2U series)
Environment Status (Displays when the ENVIROSENSOR is connected)
B. Main Menu Map
About
Hardware Version
Firmware Version
Network Information
Serial Number
Settings
Preferred Source A/B/None
Source Configuration
Nominal Voltage
Voltage Range
Freq. Deviation
Sensitivity
Load Configuration
Device
Bank/1/2/3
Overload
Threshold
Near Overload
Threshold
Low Load
Threshold
Outlet Control
Device
Bank/1/2/3
All/Outlet 1-N
Immediate On
Delay On
Immediate Off
Delay Off
Reboot
Delay Reboot
LCD Settings
Brightness
Scroll Mode
Screen Off
Reset/Reboot
Reset All (ATS PDU, RMCARD and LCD)
Reset Except TCP/IP
Reset Account (User Name and Password)
Reboot
Operation