User Manual

Replace LCD Panel

Step 1. Use slotted screwdriver to gently lift out the LCD panel.

Step 2. Disconnect cable connectors.

Step 1. Receptacle evaluation

Ensure that the plug type of your ATS unit matches the wall receptacle

type that you are using.

Electrical Installation

The ATS must be plugged into a three-wire, grounded wall receptacle only. The

wall receptacle must also be connected to an appropriate branch circuit/main

with fuse or circuit breaker protection. Connection to any other type of wall

receptacle may result in a shock hazard.

Step 2. Plug the ATS into the wall receptacle

Step 3. Attach equipment

It is extremely important not to exceed the ATS maximum current load (as

outlined in the Specifications section). In order to determine total load,

simpl

use the LCD diaplay on the front of the ATS.

Installation Guide