User Manual

ManualsBrandsCyberPower ManualsElectronicsMetered ATS PDU, 200-240V/15A, 12 Outlets, 1U Rackmount

Device Reset

●

To reset all the settings to default locally, use Reset item in the LCD display.

●

To reset all the settings to default remotely, log in Web interface, enter Reset page

and apply the function.

Unattended/Automatic Shutdown

PowerPanel Business Edition software automatically intitiates a graceful shutdown

on the operating system in an orderly fashion.

PowerPanel must be installed on every PC for which the shut down is to take

place. The PC receives SNMP messages directly from the ATS, and these messages

can be scheduled for an exact date/time, or can be performed immediately.

Follow the directions below for setting up Unattended/Automatic Shutdown.

Step 1. PC Configuration

1. Install PowerPanel Business Edition Client on every PC that will be part of the

shut down process (Follow the instructions in the PowerPanel Business Edition

Client user manual).

2. Configure the settings in PowerPanel Business Edition Client. See the

PowerPanel Business Edition Client User Manual for additional help.

Step 2. ATS Configuration

Verify that the IP address of all PCs that will be part of the shut down process are

included in the Client List of web interface (For additional information, please

refer to the user manual in the Software Installation CD).

Step 3. Notification

Notifying the PCs of potential outlet shutdown can be accomplished using the

following methods:

●

Outlets Control Menu: Performing the task of turning off or rebooting outlets

●

Scheduling Menu: Setting the scheduler to perform the task of turning off or

rebooting outlets. The notification will occur prior to the scheduled date/time.

●

Outlet Overload: In the event of ATS overload, notification will be sent prior to

the ATS shutting down.

Firmware Upgrade

By upgrading the Firmware, you can obtain new features and updates and

improvements to existing functionality.

ATS and LCD

There are two files to update in order to upgrade the firmware:

- cpsatsmafw_xxx.bin

- cpsatslafw_xxx.bin

Note that the XXX is not part of the file name but is where the version number in

the filename is given.

Use the following steps to upgrade the firmware.

1. Download the latest firmware from cpsww.com

2. Extract the file to “C:\”

3. Open Hyper Terminal to connect ATS and use the command “@NEW”

Operation