User Manual

19
©2014. CyberPower Systems, Inc. All rights reserved.
7. The system will reboot after you type “quit”. This reboot will take approx.
30 seconds
8. Login to the FTP again
- ftp
- ftp> open
- To [current IP of the RMCARD] [port] (for example: To 192.168.22.126 21)
[21 is the default ftp port for theRMCARD])
- Input USER NAME and PASSWORD
9. Upload cpssnmpdata _XXX.bin
- ftp > bin
- ftp > put cpssnmpdata _XXX.bin
10. Upgrade complete , type
- ftp > quit
11. The system will reboot after you type “quit”
Troubleshooting
Problem Possible Cause Solution
ATS outlets do not
provide power to
connected equipment
1. Breaker tripped
2. Loose power cord
Reset Breaker, check if plug is
completely connected. If the
problem remains, contact
technical support.
Amperage displayed
on LCD Display
exceeds the units
capability
Overload
The load indicator shows red
when overload. Reduce the load
on the ATS until the overload is
gone. If the problem remains,
contact technical support.
Circuit breakers have
tripped
1. Sustained overload
2. Excessive ambient or
internal temperatures
3. Faulty breaker
Reset Breaker.
If the problem remains, contact
technical support.
Conformance Approvals
FCC Warning
WARNING!! This equipment has been tested and found to comply with
the limits for a Class A Digital Device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
Any special accessories needed for compliance must be specified in the
instruction.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Notice: (1) An unshielded-type power cord is required in order to meet FCC
emission limits and also to prevent interference to the nearby radio and
television reception. It is essential that only the supplied power cord by used.
(2) Use only shielded cables to connect I/O devices to this equipment.
Note: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR
TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
The Class A digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulation.
Cet appareil numerique de la class A respecte toutes les exigencies du
Reglement sur le materiel brouilleur du Canada.
Operation