User manual
25
26
Appendix B-Power Device Network Ulity
Step 2. Assign a valid IP Address to the PDU
Option 1: Assisted Setup (recommended)
With the appropriate device selected from the Equipment List, open the Network
Settings menu (Shown in Figure 6.). [Tools=>Device Setup]. In the Device Network
Setting Menu, enter a valid IP address, subnet mask, and gateway address to setup
the PDU device.
Figure 6. Network Setting Menu (Device Setup)
Note: The DHCP option is not available for all power devices.
Step 3. Authentication
Enter the user name and password of the PDU device at the Authentication menu (Shown
in Figure 7.).
Note: The default username is “cyber” and the default password is “cyber”.
Figure 7. Authentication screen
Advanced Settings
Timeout Settings
The Timeout Setting (Shown in Figure 8.). [Edit=>Timeout Settings] is used to
specify the wait time when scanning for network PDU devices. When there are many
devices on the local network, it may take extended periods of time to locate all the
devices. The timeout function is used to limit the search time.
The default setting is 3 seconds. Valid values are 3 to 60 seconds.
Figure 8. Timeout Setting