User Manual

115
Information tab shows information about the UPS/PDU/ATS.
 Type: The type of the device, such as On-Line, Line Interactive or Sinewave Line Interactive for UPS; or
Monitored or Switched for PDU/ATS.
 Model Name: The model name of the UPS/PDU/ATS.
 Firmware Version: The firmware version of the UPS/PDU/ATS.
 MAC address: The MAC address of the UPS RMCARD, PDU or Agent computer's network interface.
 Serial Number: The serial number of the UPS.
Note: This will give the internal serial number on some models.
 Power Rating: The Volt-Amp rating (VA) and power rating (Watts) of the UPS.
 Voltage Rating: The output voltage rating (Volts) of the UPS.
 Frequency Rating: The output frequency rating (Hz) of the UPS.
 Battery Replacement Date: The date that the batteries were last replaced. This should be set at the time of
battery replacement. If this date has not been set, it is recommended that this date should be set immediately.
 External Batteries: The amount of external battery packs connected to the UPS.
 Outlets: The amount of outlets on the PDU/ATS.
UPS
The UPS tab allows you to set up to connect the PDU with the monitored UPS in the Center. Select the Connect to
UPS option. Enter UPS IP address and assign the connected outlet. Click OK button to initiate a negotiation to
connect PDU with a UPS. When the PDU connects to the UPS successfully, this PDU connects to the assigned outlet.
All Clients which have communicated with this PDU will also establish the communication with UPS.
The UPS tab also allows you to set to connect the ATS with the UPS in Center. Select the Source A connect to UPS
(or Source B connect to UPS) option. Enter UPS IP address and assign the connected outlet for according input
source of ATS. Click OK button to initiate a negotiation to connect ATS with the UPS. When ATS connects to the UPS
successfully, all Clients which have communicated with ATS will also establish the communication with UPS.
Do not connect both sources to one single UPS. An ATS whose sources come from the same UPS cannot protect
connected computers and equipment from the power outage.
When one or more Clients are detected not to establish the communication with the UPS, the Center will show a
warning to inform users of this condition.
Energy
The Energy tab shows the chart how to spend the energy in a specified period and also shows the energy statistics of
the current target node and entire system.
Each UPS, PDU, ATS and outlet of Metered by Outlet PDU whose consumption will be logged per hour and each
group which contains these UPS/PDU/ATS will work accumulating the consumption of data. These data which logged
the consumption in the past can be gathered to render a chart in a past day, a past month, a past year and a past