User`s manual

CyberPower Remote Management System
13
enabled, the UPS can be turned on without
input power.
Audible Alarm
If this option is enabled, the UPS will issue
an audible alarm when supplying battery
power or output overload.
Dry Relay Function
This configures the power condition for the
UPS dry relay to function when the selected
condition occurs. Refer to UPS manual for
further information about advanced UPS dry
relay utilization. The Dry Relay Function
provides following power conditions:
Utility Failure: The utility power fails and the
UPS is using battery power.
Low Battery: The battery capacity is too low
to support the connected computers to
shutdown.
Alarm: The UPS is issuing the audible alarm
due to the occurrence of warning events,
such as overload.
Bypass: The UPS has switched to Bypass
mode due to overload or UPS fault.
UPS Fault: The UPS could be malfunctioned
due to hardware fault, such as inverter fault,
bus fault or overheated.
Screen Saver Time
When no UPS button is pressed or no power
event occurs during this delay, the LCD
screen will be turned off.
Wiring Fault Detect
If this option is enabled, the UPS will detect if
the UPS wiring is not grounded or is
reversed. It is recommended to assure the
UPS wiring has ground connection first. This
option should be enabled if the UPS wiring
has ground connection.
Non-Critical Outlet Bank
Turn Off Threshold
When supplying battery power, the UPS will
power off the NCL outlet if the remaining
battery capacity is lower than this threshold.
Turn off Delay Time
When supplying battery power, the UPS will
power off this NCL outlet after this delay time
is met.
Turn On Delay Time
When utility power is restored, the UPS will
restore the output of the NCL outlet after the
delay time is met. This prevents excessive
power consumption caused by all the
connected equipment rebooting at the same
time.