User`s manual

CyberPower Remote Management System
16
[One Time]: The user may set a specific date and time for the UPS shutdown.
[Per Day]: Set a specific time of the day for the UPS shutdown.
[Per Week]: Set a specific day and time of the week for the UPS shutdown.
1. Click [One Time], [Per Day] or [Per Week] option and Click “Next>>”, Enter the date and
time to shut down the UPS. Select [Never], [Immediately], or the date and time for the UPS
to restore power. Select the bank to be controlled, and click “Shutdown Clients” to set all
clients to perform a graceful shutdown. You can enter a comment for this Schedule.
2. Click [Apply] to add the item to the Schedule. Click [Reset] to remove the item from the
Schedule.
3. Applied settings are listed in [Schedule] menu.
Note: The management system allows up to 10 scheduled settings.
[UPS->Wake on Lan] This function is used to wake the PC through the network. (Make sure the
PC hardware has such function supported and configures as "Enable" under BIOS). Enter the IP
address of that PC when it is on and the system will search its MAC accordingly. The maximum
number of IP that can be set is 50.
[UPS->PowerPanel Clients] Display the Information of connected PPBE (PowerPanel Business
Edition) Clients. The connection is executed by PPBE Clients and the listed clients will be
removed if disconnected for 1 hour.
[Envir] Following items can be displayed/configured through the Envir page (RMCARD 203/303
only).
[Envir->Status] Display the basic information of the environment sensor and connected devices.
Item Definition
Information
Name The name of the environment sensor.
Location The location of the environment sensor.
Temperature
Current Value The current temperature of the environment.
Maximum
The highest temperature as well as the time of
occurrence detected by the environment sensor.
Minimum
The lowest temperature as well as the time of
occurrence detected by the environment sensor.
Humidity
Current Value The current humidity of the environment.