User`s manual

CyberPower Remote Management System
21
- IPv6 Interface: Displays the current IPv6 address.
- IPv6 Gateway: Displays the current IPv6 gateway.
- IPv6 Configuration:
- Allow Access: Set the IPv6 service to either Enable or Disable.
- Router Control: The IPv6 address is assigned through the method (Stateless
Address Autoconfiguration, Stateless DHCPv6 or Stateful DHCPv6) which is
decided by router setting.
- Manual: The IPv6 address is assigned by manuel setting.
- Manual IPv6 Address : Enter the IPv6 address directly and click Apply when the
Manuel box is checked.
[System->Network Service->SNMPv1 Service] Allow users to select the NMS, defined by the
IP settings that can use the channel to control the system data access through SNMPv1 Service.
Item Definition
Allow Access Set the SNMP service to either Enable or Disable.
Community Name
The name used to access this community by a
Network Management System (NMS).
The field must be 1 to 15 characters length.
IP
The IP address or IP address mask can be accessed
by NMS. A specific IP address allows access only by
the NMS with the specified IP Address. The 255 is
regarded as the mask and the rules list as follows:
‧192.168.20.255: Access only by an NMS on the
192.168.20 segment.
‧192.255.255.255: Access only by an NMS on the
192 segment.
‧0.0.0.0 (the default setting) or 255.255.255.255:
Access by any NMS on any segment.
Access Type
The allowable action for the NMS through the
community and IP.
Read Only Gets at anytime but cannot SETS.
Write/Read
Gets at anytime, SETs anytime unless someone is
logged in the Web interface.
Forbidden No GETS or SETS.
[System->Network Service->SNMPv3 Service] Allow users to enable/disable SNMPv3 service
and configure the parameters of accessing through SNMPv3 service (HW V2.0 above only).
Item Definition
Allow Access Set the SNMPv3 service to either Enable or Disable.