User`s manual

CyberPower Remote Management System

Reset to Default Setting / Recover from a Lost Password

To reset the CyberPower Remote Management Card to its default setting (including WEB log-in

user name and password), please use the following steps

RMCARD202 RMCARD203

RMCARD302 RMCARD303

1. Remove the two retaining screws on the card without turning off the UPS.

2. Uninstall the card.

3. Take off the jumper on the Reset pins as illustrated (the jumper is still necessary after reset,

please do not lose or dispose it).

4. Re-install the card into the expansion port.

5. Wait until the Green LED is flashing (the frequency of the ON/OFF flashing is one second).

6. Uninstall the card again.

7. Place the jumper back onto the Reset pins.

8. Install card into the expansion port again.

9. Tighten the retaining screws.

RESET