User`s manual

CyberPower Remote Management System
6
Figure 2. The setting window.
6. To modify the IP Address, Subnet Mask or Gateway address, enter the new addresses into
the corresponding fields.
7. You will need to enter a User Name and Password for the Remote Management Card
(Figure 3) in the authentication window, as shown in figure 3.
*Default user name: cyber; Default password: cyber
Figure 3. The authentication window.
8. If IP address is successfully set, you will see a message that the IP set up is OK, as shown
in Figure 4.
.
Figure 4. Setup IP Address successfully message.