User`s manual

CyberPower Network Management System
4
Definitions for LED Indicators
Link LED color Condition
Off
The Network Management Card is not connected to the Network/
or the Network Management Card Power is off
On(Yellow) The Network Management Card is connected to the Network
TX/RX LED color
Off The Network Management Card power is off
On(Green) The Network Management Card power is on
Flash
- Receiving/transmitting data packet
- Reset finished
Step 2. Configure the IP address for the CyberPower Network Management Card.
Method 1 : Using the CyberPower Power Device Network Utility Tool
1. Install the CyberPower Power Device Network Utility Tool from the included CD. It is located
on the CD in the \tools\network folder. Double click the “Power Device Network Utility”
installation file, “Setup.msi” to begin the installation.
2. After installation is complete, run the “Power Device Network Utility” program. Under “All
Programs, Select ”CyberPower Power Device Network Utility”.
3. The main dialog of the “Power Device Network Utility Tool” program is shown in Figure. 1. The
configuration tool will display all CyberPower network cards of present on the same network.
The "Refresh" button is used to search the entire local network for SNMP cards.
○
○○
○
1 Ethernet connector
○
○○
○
2 LINK Indicator
○
○○
○
3 RX/TX Indicator