User`s manual

CyberPower Remote Management System
10
Working Frequency The output frequency rating(Hz) of the UPS.
Power Rating The Volt-Amp rating of the UPS.
Current Rating The output current rating(Amps) of the UPS
Load Power The power rating(Watts) of the UPS.
Battery Voltage Rating The DC voltage rating of the battery set.
Firmware Version The version number of the UPS firmware.
Battery Replacement Date
The date that the batteries were last replaced and it
can only be set at the time of battery replacement.
This date should be set after the battery
replacement. If this date is not set, it is
recommended that this date should be set
immediately.
Non-Critical Bank The amount of the Non-Critical Load.
External Batteries
The amount of the external battery packs connected
to the UPS.
Installation Place
When clicking the “Find it” button, either the alarm
will beep or the indicators will sparkle to inform
users. This helps users to identify the specific UPS
among all UPSs.
[UPS->Configuration] Configures the parameters of the UPS.
Utility Power Failure Condition
High/Low Voltage Threshold
When the utility power voltage is
higher/lower the threshold, the UPS will
supply battery power to the connected
equipment. This setting only comes into
effect after a restart of UPS.
Power Restore
After the utility power restores, the UPS
turns on automatically and supplies power to
the computer. If the computer BIOS is set to
boot when power restores, the computer will
restart automatically. The following settings
are used to configure the UPS restore
actions:
Recharged Delay
When the utility power restores, the UPS will
start to recharge after the specified delay is
expired.