User`s manual

CyberPower Remote Management System
20
Forbidden No GETS or SETS.
[System-> Network Service->Telnet Service] Selects Enable to allow access to the Telnet
Service and configures the TCP/IP port that Telnet uses to communicate (23 by default).
Note: To enhance security, users can change port setting to any unused port from 5000 to
65535. Users must then specify the non-default port to obtain access. Telnet clients
require users to append either a space and the port number or a colon and the port
number to the command line to access the control console.
[System-> Network Service->FTP Service] Allows users to Enable/Disable the FTP server
service and configure the TCP/IP port of the FTP server (21 by default).
Note: The FTP server is used for upgrading Firmware. For more details about the upgrade
process, please refer to “Firmware Upgrade” section.
[System->About] Displays vital information for the Remote Management Card.
Items Definition
Model Name Model name of the Remote Management Card.
Firmware Version
The version number of the current firmware installed
on Remote Management Card.
Firmware Updated Date The date the firmware was last updated.
Hardware Version
The hardware version of the Remote Management
Card.
MAC Address
MAC address of the Remote Management Card.
Note: the MAC address is also listed on the top of the
Remote Management Card.
Save Configuration
Click Save to save the configuration to local PC. The
text file will have a default format of
YYYY_MM_DD_HHMM.txt.
Restore Configuration
Use this function to restore a configuration that has
been saved earlier. Click Browse to the location of the
saved configuration file and click Submit.