User`s manual

CyberPower Remote Management System
21
RESET
Reset to Default Setting / Recover from a Lost Password
To reset the CyberPower Remote Management Card to its default setting (including WEB log-in
user name and password), please use the following steps.
1. Remove the two retaining screws on the card without turning off the UPS.
2. Uninstall the card.
3. Take off the jumper on the Reset pins as illustrated.(The jumper is still necessary after reset ,
please do not lose or dispose of it)
4. Re-install the card into the expansion port.
5. Wait until the Green LED is flashing (the frequency of the ON/OFF flashing is one second).
6. Uninstall the card again.
7. Place the jumper back onto the Reset pins.
8. Install card into the expansion port again.
9. Tighten the retaining screws.
Firmware Upgrade
By upgrading the Firmware, you can obtain both the new features and updates/improvements to
existing functionality. There are two files to update in order to upgrade the firmware version:
- cpssnmpfw_XXX.bin
- cpssnmpdata_XXX.bin
Use the following steps to upgrade the firmware.
1. Download the latest Firmware.
2. Extract the file to “C:\”
3. Open a command prompt window
4. Login to the CyberPower Remote Management Card with FTP command, type
- ftp
- ftp> open
- To [ip] [port] ; EX: To 192.168.22.126 21
- Input USER NAME and PASSWORD (same as the administrator account in Web
interface default : cyber ; cyber)
5. Upgrade the cpssnmpfw_XXX.bin , type