Installation Manual

1
INSTALLATION GUIDE
Step 1. Hardware Installation
1. Remove the two retaining screws
of the expansion port cover, and
then remove the cover.
2. Install the CyberPower Remote
Management Card into the
expansion port.
3. Re-install and tighten the retaining
screws.
4. Connect the Ethernet cable to the
Ethernet connector of the
CyberPower Remote Management
Card.
5. (Optional) To connect with the
environmental sensor, use a
RJ45 Ethernet cable. Connect
one end to the Universal port on
the RMCARD and the other end
into the sensor. For further
information, please refer to the
ENVIROSENOR user’s manual.
NOTE: The CyberPower Remote Management Card is a hot-swap device, so you do
not need to turn off the UPS to install it.
RMCARD205
RMCARD305