Installation Manual

3
2. After installation completes, run the “Power Device Network Utility”.
3. The main dialog of the Power Device Network Utility Tool program is
shown in Figure 1. The configuration tool will display all CyberPower
Remote Management devices present on the same network subnet. The
"Refresh" button is used to search the local network subnet again.
Figure 1. The main window of the “Power Device Network Utility” program.
4. Select the Remote Management Card you are setting up. Click on the
Tools menu and select “Device Setup” or double click the Remote
Management Card you want to configure.
5. You can modify the IP Address,
Subnet Mask, and Gateway address
for the Device MAC Address listed in
the Device Network Settings window,
as shown in Figure 2. The default IP
Address is 192.168.20.177 and the
default Subnet Mask is
255.255.255.0.
6. Modify the IP, subnet mask or
gateway address. Enter the new
addresses into the corresponding
fields.
Figure 2. The Device Network setting window.
Step 1. Hardware Installation
LINK Indicator
Ethernet connector
RX/TX Indicator
RMCARD203
Universal Link RX/TX
Universal connector