Installation Manual

WEB INTERFACE Login User Account

You can select a preferred language, and will need to enter a User Name

and Password to login to the interface. There are two user account types.

1. Administrator

*Default username: cyber

Default password: cyber

2. View only

*Default username: device

Default password: cyber

The administrator can access all functions, including enable/disable the view

only account. The viewer can access read only features but cannot change

any settings.

Trouble Shooting

Problem

Solution

Unable to configure

the Remote

Management Card

by method 1 or

method 2

1. Check the LED status, the condition is normal

when the yellow and green LEDs are both on.

If green LED is off :

►Check if the Remote Management Card is

properly seated in the UPS and the UPS

power is connected to working electrical

outlet.

If yellow LED is off :

►Ensure the network connection is good.

2. Ensure the PC being used is on the same

network subnet as Remote Management Card.

Unable to ping the

Remote

Management Card

1. Use method 1 and method 2 to get/set a correct

IP address for the Remote Management Card.

2. If the PC being used is on a different network

subnet from the Remote Management Card,

verify the setting of subnet mask and the IP

address of gateway.

Lost the user name

and password

Please refer to the “Reset to Default Setting /

Recover from a Lost Password” section in the

RMCARD User’s Manual.