User Manual

CyberPower Remote Management System
23
[System->Network Service->TCP/IPv4] Display the current TCP/IPv4 settings. Set DHCP and DNS
server settings.
Item
Definition
Current Configuration
Displays the current TCP/IP settings: IP address, subnet mask, gateway,
and DNS server.
DHCP
Select the “Enable DHCP” option and click “Apply” to get IP address,
Subnet Mask, and Gateway from DHCP server. Select the “Obtain DNS
Address from DHCP” and click “Apply” to get the IP of DNS from the
DHCP server.
Manual
Enter the TCP/IP settings directly and click “Apply”.
[System->Network Service->TCP/IPv6] Display and configure the current IPv6 settings.
Item
Definition
IPv6 Interface
Displays the current IPv6 address.
IPv6 Gateway
Displays the current IPv6 gateway.
IPv6 Configuration
Access
Set the IPv6 service to either Enable or Disable.
Address Mode
Router Control
The IPv6 address is assigned through one of the following methods as
configured in the router settings: Stateless Address Auto-configuration,
Stateless DHCPv6 or Stateful DHCPv6.
Manual
The IPv6 address is assigned manually.
Manual IPv6 Address
Enter the IPv6 address directly when the Manual setting is selected.
[System->Network Service->SNMPv1 Service] Allow users to use a NMS and configure the
appropriate SNMPv1 settings.
Item
Definition
SNMPv1 Service
Allow Access
Set the SNMP service to either Enable or Disable.
SNMPv1 Access Control
Community
The name used to access this community from a Network Management
System (NMS). The field must be 1 to 15 characters in length.
IP Address
NMS access can be restricted by entering a specific IP address or an IP
network subnet mask. The following subnet mask rules apply:
• 192.168.20.255: Access only by an NMS on the 192.168.20 segment.
• 192.255.255.255: Access only by an NMS on the 192 segment.
• 0.0.0.0 (the default setting) or 255.255.255.255: Access by any NMS
on any segment.