User Manual

CyberPower Remote Management System
45
Reset to Factory Default Setting / Recover from a Lost Password
To reset the CyberPower Remote Management Card to its factory default setting (including web log-in
user name and password), please following these steps:
RMCARD205
RMCARD305
1. Remove the card from the UPS without turning the UPS off.
2. Remove the jumper from the reset pins as illustrated. Do not dispose of the jumper.
3. Insert the card into the expansion port.
4. Wait until the Green LED is flashing (the frequency of the ON/OFF flashing is once per second).
5. Remove the card again.
6. Place the jumper back onto the Reset pins.
7. Install card into the expansion port again and tighten the retaining screws.