User Manual

CyberPower Remote Management System
3
Installation Guide
Step 1. Hardware Installation
Expansion Slot
1. Remove the two retaining screws from the expansion slot and remove the cover.
2. Install the CyberPower Remote Management Card into the expansion slot.
3. Insert and tighten the retaining screws.
4. Connect an Ethernet cable to the Ethernet port of the CyberPower Remote Management Card.
5. (Optional) To connect the environmental sensor, use a RJ45 Ethernet cable. Connect one end to the
Universal port on the RMCARD and the other end into the sensor. For more information, please see
the ENVIROSENOR user’s manual.
Note: The CyberPower Remote Management Card is hot-swappable, so you do not need to turn
off the UPS to install it.
RMCARD305
RMCARD205