User Manual

CyberPower Remote Management System
53
2. Select an IP Address for the CyberPower Remote Management Card
Verify the IP Addresses for the computer and the Remote Management Card belong to the same subnet.
Refer to the above network information, the possible IP Address for the Remote Management Card
could be 192.168.20.* (* hereafter represents any number between 1 and 255). Similarly, if the Subnet
Mask is 255.255.0.0, the IP Address for Remote Management Card could be set up as 192.168.*.* to
reach the same subnet with the computer.
To verify there is no other equipment connected to the network using the same IP Address, run “Ping
192.168.20.240” at the DOS Mode prompt when the IP Address you would like to set is
192.168.20.240. If the response is presented as below, the IP address is most likely not used and
may be available for the CyberPower Remote Management Card.
Pinging 192.168.20.240 with 32 bytes of data:
Request timed out.
Request timed out.
Request timed out.
Request timed out.
If the response is shown as below, the IP address is in use. Try another IP address until an available
address is found.
Pinging 192.168.20.240 with 32 bytes of data:
Reply from 192.168.20.240: bytes=32 time<10ms TTL=64
Reply from 192.168.20.240: bytes=32 time<10ms TTL=64
Reply from 192.168.20.240: bytes=32 time<10ms TTL=64
Reply from 192.168.20.240: bytes=32 time<10ms TTL=64