PRODUCT REGISTRATION Thank you for purchasing a CyberPower product. This UPS is designed to provide unsurpassed power protection, operation, and performance during the lifetime of the product. Please take a few minutes to register your product at: www.CyberPowerSystems.com/registration. Registration certifies your product’s warranty, confirms your ownership in the event of a product loss or theft, and entitles you to free technical support.
INSTALLING YOUR UPS SYSTEM UNPACKING Inspect the UPS upon receipt. The box should contain the following: (a) UPS unit (b) User’s manual (c) USB device cable PowerPanel® software is available on our website. Please visit www.cyberpowersystems. com and go to the Software Section for a free download. 3. Plug the UPS into a 2-pole, 3-wire grounded receptacle (wall outlet). Make sure the wall branch outlet is protected by a fuse or circuit breaker and does not service equipment with large electrical demands (e.
BASIC OPERATION 4. Full-Time Surge Protection Outlets 1. Power On Switch To turn the UPS on, press the power button for approximately 2 seconds - you will hear a constant tone (1 second) - and release after a short beep. To turn the UPS off, press the power button for approximately 2 seconds - you will hear a constant tone (1 second) - and release after two short beeps. Alarm setting: The audible alarm can be turned OFF or ON by quickly pressing the POWER button twice.
TROUBLESHOOTING Problem Possible Cause Full-time surge protection outlets stop providing power to equipment. Circuit breaker button is projecting from the side of the unit. The UPS does not perform expected runtime. The UPS will not turn on. PowerPanel® Personal is inactive (all icons are gray). Solution Circuit breaker has been tripped due to an overload. Turn the UPS off and unplug at least one piece of equipment. Reset the circuit breaker by depressing the button, and then turn the UPS on.
TECHNICAL SPECIFICATIONS Model XC625 Capacity 625 VA / 360 W Nominal Input Voltage 120 Vac Input Frequency 50 to 60 Hz +/- 3 Hz On-Battery Output Voltage 120 VAC +/- 5% On-Battery Output Frequency 50 Hz to 60 Hz +/- 1 % (auto-sensing) Max. Load for UPS Outlets 625 VA / 360 W Max.