Owners manual

CyberPower Remote Management System
10
Firmware Version
The revision number of the UPS firmware.
USB Version
The revision number of the UPS USB firmware
LCD Version
The revision number of the UPS LCD firmware
Battery Replacement Date
The date that the batteries were last replaced. This must be set
manually and should be set after the batteries have been replaced or
when the unit is first installed. If this date has not been set, it is
recommended that this date should be set immediately.
NCL
The amount of the Non-Critical Load.
Extended Battery Pack
The amount of the external battery packs connected to the UPS. The
number of packs is configured manually, and the configurations will
vary by model.
Installation Place
When clicking the “Find it” button, either the alarm will beep or the
indicators will flash to inform users of the location. This helps users to
identify a specific UPS in a multiple UPS installation.
[UPS->Configuration] Configure the parameters of the UPS.
Item
Definition
Supplied Power
Voltage
Set the output voltage which is supplied to the connected equipment.
Utility Power Failure
Condition
High/Low Input (or
Output) Voltage
Threshold
When the utility power voltage or output voltage (depending on UPS
model) is higher/lower than the threshold, the UPS will supply battery
power to the connected equipment. This setting only comes into
effect after a restart of the UPS.
Utility Sensitivity
When the UPS detects the utility voltage is out of range, the UPS will
switch to battery mode to protect the equipment plugged into the
UPS. Low sensitivity has a looser voltage range and the supplied
power may vary more widely. The power from fuel generator may
cause the UPS to switch to battery mode more frequently, and the
low sensitivity is recommended. The UPS switches to battery mode
rarely and also saves more battery power. High sensitivity allows the
UPS to supply the more stable power to equipments and switches to
battery mode frequently.
Frequency Tolerance
Sets the acceptable range of the input frequency. The UPS will
supply battery power to the connected equipment if it is out of
tolerance.
Operation
Normal
Normal operating mode of the UPS.
Generator Mode
If the UPS uses generator as its input power, this option should