User`s manual

Installation

Operating System Installation

Windows 95/98/ME/NT/2000/XP

Do not install the Adapter in the machine until the software has been fully installed.

1. Start Windows.

2. Insert the CD in to your CD drive.

3. If ‘Auto-Start’ is enabled for this drive the software will automatically launch. Otherwise, point your

browser to the ‘Index.htm’ on the root of the CD

4. Select ‘Install Software’.

5. Select the part number for your adapter from the listing.

6. Select ‘Windows 95/98/ME/NT/2000/XP’ then (depending on the OS version) select the ‘Run from the

current location’ or ‘Open’ option. Follow the information presented on the screens that follow.

Physical Installation

The adapter can be installed in any PCI (5V or 3.3 V) expansion slot.

Do not install the Adapter in the machine until the software has been fully installed.

1. Turn off PC power. Disconnect the power cord.

2. Remove the PC case cover.

3. Locate an available PCI slot and remove the blank metal slot cover.

4. Gently insert the PCI adapter into the slot. Make sure that the adapter is seated properly.

5. Replace the screw. (This is required to ensure FCC Part 15 compliance.)

6. Replace the cover.

7. Install the cable (if applicable)

8. Connect the power cord

Installation is finished.

COMHP 7804 CyberResearch

Serial Communication