User`s manual

•

CYMOD 4531

5.4.18 Read Command Leading Code Setting

@Description

Read command leading code setting status.

@Syntax

~(Addr)0<CR>

~ Command leading code.

(Addr) Address ID

0 Read command leading code setting.

@Response

!(Addr)(Status)(C1)(C2)(C3)(C4)(C5)(C6)<CR>

?(Addr)<CR>

! Command is valid.

? Command is invalid.

(Addr) Address ID

(Status) (2-character)

Bit 0 : Reserved

Bit 1 : Power failure or watchdog failure

Bit 2 : Host watchdog is enable

Bit 3 : Host failure

(C1) Leading code 1, for read configuration status,

firmware version, etc. default is $.

(1-character)

(C2) Leading code 2, for read synchronize sampling,

digital output ,default is #. (1-character)

(C3) Leading code 3, for change configuration.

default is %. (1-character)

(C4) Leading code 4, for read alarm status, enable

alarm, etc. default is @. (1-character)

(C5) Leading code 5, for read command leading

code, change command leading code, etc.

default is ~. (1-character)

(C6) Leading code 6, this leading code is reserved.

Default is *. (1-character)