User`s manual

3
2
Installation and Configuration
Installing the CYDAS UDR Library
To install the CYDAS UDR Library, follow the steps below
1. Place the CYDAS UDR Library CD in your CD drive.
The
CyberResearch CD dialog opens.
If the dialog does not open, use Windows Explorer to run the setup.exe on the root of the CD.
2. From the
CyberResearch CD dialog, click on the Install InstaCal and the CYDAS UDR Library button.
3. Follow the installation instructions as prompted.
4. Leave the CYDAS UDR Library CD in your CD drive, and restart your computer.
InstaCal is a powerful installation, test, and calibration software package that is installed as part of the
CYDAS UDR Library package. Refer to the Quick Start Guide for examples of using InstaCal with DEMO
BOARD
The CB.CFG file and InstaCal
All board-specific information, including current installed options, are stored in the file CB.CFG which is read
by CYDAS UDR Library. InstaCal creates and/or modifies this file when board configuration information is
added or updated. The CYDAS UDR Library will not function without the CB.CFG file.
For this reason, you must use InstaCal to modify all board setups and configurations as well as to install or
remove boards from your system.
Installation – .NET support
CYDAS UDR Library support for .NET requires that the Microsoft .NET framework already be installed on
the system before you install the CYDAS UDR Library.
Installation – HP VEE support
Before installing HP VEE support, install the CYDAS UDR Library and InstaCal.
After you install the HP VEE application and drivers, run InstaCal and configure the driver. InstaCal is an
installation, calibration, and test program that creates a required configuration file describing the specifics of
the hardware installed.
The changes made to your system when installing HP VEE Support are identical to the changes made when
installing the CYDAS UDR Library, except for the following:
 The menu bar program VEE.MNU (or CBI.MNN, depending on the version) is written to the VEE
directory.